A.The configuration is incorrect as Line 8 should be poke-sdp 42 mpls create

B.The configuration is incorrect as VPRN service does not support spoke-sdp configuration using MPLS LSPs

C.The configuration is complete and correct

D.The configuration is incomplete as the uto-bind command is missing

E.The configuration is incomplete as the ignaling off command is missing

A.PE1 and PE2 advertise the same VPN route to the route reflector.

B.The route reflector receives two routes for prefix 10.1.1.0/24; one from PE1 and one from PE2.

C.The route reflector reflects two routes for prefix 10.1.1.0/24.

D.PE3 receives two routes and is able to load balance traffic across PE1 and PE2.

A.This command is required on the ASBRs to exchange labeled IPv4 routes between the ASs.

B.This command is required on all PE routers to distribute labeled IPv4 routes to connected CEs.

C.This command is required on all PE routers to distribute labeled IPv4 routes directly to PEs in remote AS.

D.This command is required on the route reflectors to exchange customer routes between ASs as labeled IPv4 routes.

A.The ability to maintain its own backbone.

B.The ability to offer Internet connectivity and a variety of services over a single CSC VPRN interface.

C.There is no need to manage end-customer services.

D.The ability to learn system addresses of network provider PEs.

A.Model B is highly scalable because the VPN-IPv4 routes are neither maintained, nor distributed by, the ASBRs.

B.Model B requires the configuration of back-to-back VRFs between the ASBRs in different autonomous systems.

C.There is a dependency between the route target used in different autonomous systems.

D.Model B supports the exchange of labeled IPv4 routes between ASBRs.