Online Access Free CWNP.CWAP-404.v2025-07-12.q85 Practice Test (Page 18)

CWAP-404 Exam Question 81

Given: Adjacent Channel Interference (ACI) can cause frame corruption and poor performance in WLANs. You are using a protocol analyzer in the attempt to detect ACI.
What should you look for in such a scenario?

A.Look at Retry counts

B.Look at CRC errors

C.Look for frames with a low signal strength value in the radio tap header

D.Capture on the channel you think may be impacted by ACI and see if any frames are captured from adjacent channels

CWAP-404 Exam Question 82

You have been asked to recommend a solution for protocol capture of 802.11 frames consisting of 3x3:3 802.11ac communications. The requirement specifies that you gain a general view of a coverage area and does not require that you capture from specific user locations. The solution must be the least expensive practical solution possible that does not disrupt user access to the WLAN and it must be based on enterprise WLAN hardware.
What solution would you recommend so that any coverage area could be monitored on demand?

A.Install Wireshark on the Aps natively to allow dynamic capture while serving clients

B.Install the minimum number of Aps required for coverage and use these Aps for protocol analysis as needed

C.Install laptop-based protocol analyzer near each AP

D.Install sufficient Aps so that an AP can be taken offline to perform protocol analysis as needed

CWAP-404 Exam Question 83

What is the function of the PHY Preamble?

A.To set the modulation method for the MPDU

B.Allows the receiver to detect and synchronize with the signal

C.To terminate a conversation between transmitter and receiver

D.Carries the NDP used in Transmit Beamforming and MU-MIMO

CWAP-404 Exam Question 84

What HT PPDU format is shown in the exhibit?

A.Non-HT duplicate format

B.Non-HT format

C.ERP-OFDM format

D.HT-greenfield format

E.Dual Training Field format

F.HT-mixed format

CWAP-404 Exam Question 85

What is the formula used to calculate the Duration field value in an RTS frame?

A.RTS Duration field = Data or management frame to be sent duration + CTS duration + one ACK duration + three SIFS

B.RTS Duration field = Data or management to be sent frame duration

C.RTS Duration field = CTS duration

D.RTS Duration field = Data or management frame to be sent duration + CTS duration

Other Version: 2596CWNP.CWAP-404.v2025-03-12.q87

Latest Upload: 140CrowdStrike.CCSE-204.v2026-06-12.q25; 160VMware.2V0-17.25.v2026-06-12.q49; 147Appian.ACA-100.v2026-06-11.q23; 201CompTIA.220-1202.v2026-06-11.q114; 162CheckPoint.156-590.v2026-06-11.q47; 220CompTIA.220-1202.v2026-06-10.q109; 190CertiProf.CEHPC.v2026-06-10.q54; 150Hitachi.HQT-4160.v2026-06-10.q25; 387PMI.PMI-ACP-CN.v2026-06-09.q453; 190Splunk.SPLK-5002.v2026-06-08.q52

CWAP-404 Exam Question 81

CWAP-404 Exam Question 82

CWAP-404 Exam Question 83

CWAP-404 Exam Question 84

CWAP-404 Exam Question 85

Download PDF File