Online Access Free CWNP.CWDP-304.v2024-05-06.q79 Practice Test (Page 15)

CWDP-304 Exam Question 66

What is the most suitable antenna option to be used when designing a WLAN infrastructure with APs mounted on a ceiling with a height of more than 20 feet and having all of the client stations used from the floor?
Response:

A.Grid

B.Patch

C.Low-gain dipole

D.Dish

CWDP-304 Exam Question 67

What architecture suffers the biggest limitation for sharing control information across APs?
Response:

A.Distributed

B.Centralized

C.Independent autonomous

D.Controller

E.Cooperative autonomous

CWDP-304 Exam Question 68

After designing a WLAN infrastructure using predictive design software. What's the best way to validate the predictive design in the physical space before deployment, if time and budget allow for it?

A.Deploy all of the APs as they're shown in the predictive design and perform an active site survey.

B.Deploy all of the APs as they're shown in the predictive design and perform a passive site survey.

C.Use a client device positioned where the APs will be installed and measure the signal from the client device.

D.Perform an AP-on-a-Stick survey using AP locations based upon the predictive design to confirm each AP's placement.

CWDP-304 Exam Question 69

Which definition correctly describes the "local MAC" variation of the centralized WLAN architecture?

A.PHY functions are performed directly by the AP. MAC functions are divided almost equally between the WLAN controller and the AP, according to the time sensitivity of the feature or service.

B.All RF-, data-, and control-related WLAN functions are performed by the AP. APs coordinate network services with one another and are managed by a WNMS,

C.The AP provides the RF termination point for the WLAN, but performs very few of the WLAN functions or services. The WLAN controller performs all MAC functions and the AP is very simple and lightweight.

D.All MAC functions are performed by the AP. A minimal subset of network control is offloaded to the WLAN controller along with management and monitoring functions.

CWDP-304 Exam Question 70

Before performing a pre-deployment passive RF survey of a new deployment using survey mapping software, which of the following must be performed?

A.Scaling the map

B.Determining AP transmit power

C.Checking client DTPC settings

D.Selecting antennas

Latest Upload: 142CrowdStrike.CCSE-204.v2026-06-12.q25; 161VMware.2V0-17.25.v2026-06-12.q49; 150Appian.ACA-100.v2026-06-11.q23; 208CompTIA.220-1202.v2026-06-11.q114; 163CheckPoint.156-590.v2026-06-11.q47; 224CompTIA.220-1202.v2026-06-10.q109; 204CertiProf.CEHPC.v2026-06-10.q54; 151Hitachi.HQT-4160.v2026-06-10.q25; 400PMI.PMI-ACP-CN.v2026-06-09.q453; 192Splunk.SPLK-5002.v2026-06-08.q52

CWDP-304 Exam Question 66

CWDP-304 Exam Question 67

CWDP-304 Exam Question 68

CWDP-304 Exam Question 69

CWDP-304 Exam Question 70

Download PDF File