NicoCo is building a new facility and would like to install a WLAN for primary connectivity of all clients. The requirements are dual-spectrum 802.11n supporting voice and location tracking.
What type of pre-deployment survey should be performed?
Response:

When selecting a centralized WLAN architecture, what new problem may arise when you change the data forwarding model from centralized to distributed?
Response:

A designer has created a WLAN design that has been implemented in an organization. The network exists in a four-story building Because each floor has an Identical floor plan, the designer designed only one floor and had the installers duplicate the design on each floor. Now. in validation, it is not performing well What best explains the problem caused by this process?

As an implementation engineer, you have just received initial design specs from a network designer for your dual-band 802.11n deployment. The network design documents prescribe the following data rate configuration for the 2.4 GHz radio:
Basic Rates 5.5, 6, 11, 12 Mbps
Supported Rates 9, 18, 24, 36, 48, and 54 Mbps as well as MCS 0-15
What will result from this design strategy?

During a validation site survey, you realize that the installers mounted some of the APs above the ceiling. They said that this was a request from the building architect due to aesthetics constraints. During the requirements gathering, you weren't advised about any aesthetics constraints from the main stakeholder of the project. What should you do in this case?