A.Increased amplitude of the RF signal

B.Fewer MCS values in the MCS table

C.Increased range of the RF signal

D.Excessive VSWR

A.Active Amplification

B.Directed Radiation

C.Beam Digression

D.Passive Gain

A.When using CAT5 cabling, you increase the maximum draw available to the PD over that available with CAT6.

B.Only endpoint PSEs are supported.

C.The lowest voltage drop is achieved when using CAT6 cable instead of CAT5 or CAT5e.

D.Only midspan PSEs are supported.

A.Performing protocol analysis with a single wireless adapter that is scanning all channels in use

B.Testing a constant conversation orhandset tone while roaming from area to area, or performing an active survey

C.Configuring DSCP-to-802.11e QoS maps on the handset for each access category.

D.Verifying the VHT functionality to handle the call volume incurred by a single VoIP phone call.

A.RF cables have upper and lower frequency range specifications.

B.Large diameter RF cables cause greater loss than small diameter cables.

C.Every RF connector causes insertion loss.

D.75 and 125 ohms are the typical impedances of 802.11 WLAN connectors.

E.Two RF connectors of the same type (e.g. SMA), manufactured by different companies, may vary in specifications.