After the initial installation on Check Point appliance, you notice that the Management interface and default gateway are incorrect. Which commands could you use to set the IP to 192.168.80.200/24 and default gateway to 192.168.80.1.

You want to define a selected administrator's permission to edit a layer. However, when you click the + sign in the "Select additional profile that will be able edit this layer" you do not see anything. What is the most likely cause of this problem? Select the BEST answer.

VPN gateways must authenticate to each other prior to exchanging information. What are the two types of
credentials used for authentication?

Review the following screenshot and select the BEST answer.

What are the three components for Check Point Capsule?