See the Explanation.Explanation:
1- SSH into the gateway.
2- Run: cpstat antimalware and cpstat anti-bot.
3- Confirm both blades are "Active" and signatures are "Up-to-date."
4- Check with cpview > Threat Prevention section.
5- Use watch -n 5 cpstat antimalware to monitor real-time status.

See the Explanation.Explanation:
1- SSH into the gateway.
2- Use: curl -v https://updates.checkpoint.com
3- Confirm DNS resolves and certificate is valid.
4- Check proxy settings if blocked.
5- Verify SmartConsole > Gateways > Update section reflects success.

See the Explanation.Explanation:
1- SSH into the Gateway.
2- Run: tecli debug on or pdp debug on.
3- Reproduce the issue.
4- View logs in $FWDIR/log/.
5- Disable debug mode: tecli debug off.

See the Explanation.Explanation:
1- Edit your custom Threat Prevention profile.
2- Under the Anti-Bot section, enable DNS Reputation.
3- Set to Prevent on High Confidence queries.
4- Ensure "Inspect DNS traffic" is enabled.
5- Save and apply the profile.

See the Explanation.Explanation:
1- Open SmartConsole > Gateways & Servers.
2- Double-click the relevant Security Gateway.
3- Under the "General Properties" tab, enable "Anti-Bot" and "Anti-Virus."
4- Click OK > Publish the changes.
5- Install the Access Control and Threat Prevention policy.