Explanation
The asg_perf_hogs command is a script that displays the processes that are consuming excessive system resources, such as CPU, memory, disk, and network, on the orchestrator and the appliances. It can help identify performance issues and bottlenecks in the Maestro environment.
References
*Software Provision and Performance hogs failed - Check Point CheckMates1
*CHECK POINT MAESTRO EXPERT, page 33

Explanation
The asg calc command is a tool to show which SGM is selected to receive traffic based on the distribution mode and the packet parameters. It takes the port number, the source IP, the destination IP, and optionally the source port and the destination port as arguments and returns the SGM ID and the hash value. For example, asg calc 1 10.0.0.1 20.0.0.2 1234 80 will show which SGM will receive the traffic from 10.0.0.1:1234 to
20.0.0.2:80 on port 1.
References
*Check Point Certified Maestro Expert (CCME) R81.X Courseware, Module 4: Using theCommand Line Interface and WebUI, Lesson 4.1: asg calc, page 4-5
*Check Point R81 Maestro Administration Guide, Chapter 4: Using the Command Line Interface and WebUI, Section: asg calc, page 4-5
*asg calc - Check Point Software

Explanation
The Correction Layer mechanism is a Maestro component that ensures that packets from the same connection are handled by the same Security Group Module (SGM) in a multi-appliance system. This is especially important when NAT or VPNs are involved, as packets sent from the client to the server can be distributed to a different SGM than packets from the same session sent from the server to the client. The Correction Layer must then forward the packet to the correct SGM.
References:
*NAT and the Correction Layer on a VSX Gateway - Check Point Software1
*Solved: Maestro queries - Check Point CheckMates

Explanation
This command is used to set the number of sites in a Maestro environment, which can be either one or two.
The number of sites determines the site-sync configuration and the failover policies for the Security Groups and the Security Group Members. The default value is one, and it can be changed only before the first Security Group is created.
References =
*Maestro basic setup documentation - Page 2 - Check Point CheckMates
*Check Point R81.10 for Scalable Platforms - Check Point Software
*CHECK POINT MAESTRO EXPERT

Explanation
The g_update_conf_file command is a global command that allows users to update the specified file on all Security Group Members of the current Security Group. The command takes the file name and the parameter-value pair as arguments and updates the file accordingly. For example, g_update_conf_file fwkern.conf fwha_enable_arp=1 will add or modify the fwha_enable_arp parameter in the fwkern.conf file on all SGMs.
References
*Check Point Certified Maestro Expert (CCME) R81.X Courseware, Module 4: Using the Command Line Interface and WebUI, Lesson 4.3: Global Commands, page 4-12
*Check Point R81 Maestro Administration Guide, Chapter 4: Using the Command Line Interface and WebUI, Section: Global Commands, page 4-10
*Maestro Commands for Security Groups - Check Point CheckMates