RJ-45 is the standard connector used for Ethernet networks. Here's why it's the correct answer:
Compatibility: Ethernet ports on both laptops and Cisco switches use RJ-45 connectors. This makes RJ-45 cables ideal for direct connections between these devices.
Appearance: RJ-45 ports are rectangular and slightly larger than typical phone jacks (RJ-11). They have eight metal pins inside.
Why other options are incorrect:
DVI: DVI ports are used for video connections between computers and displays.
RJ-11: RJ-11 ports are primarily associated with analog phone lines and are smaller than RJ-45.
DB-9: DB-9 connectors were traditionally used for serial connections on older computers and peripherals.

In the context of IPv4 addresses, a host address is an identifier for a specific device on a network. The addresses 10.1.1.20 and 192.168.10.15 are both within ranges typically reserved for private networks, making them suitable for assignment to host computers within a local network. Address 292.10.3.4 is not a valid IPv4 address because the first octet is beyond the maximum value of 255. Address 255.255.255.255 is reserved for broadcast messages to all hosts on the local network, and 0.0.0.0 is used to denote an unspecified address, often indicating the absence of an IP address123. Reference := IP address, Network address, and Host address Explained, IP address - Wikipedia, Understanding IP Addresses: How IP Addressing Works | ENP

The address that facilitates the routing of packets over an IP network is the network address. In the context of IP networking, this refers to the IP address, which is used to identify each host on a network and to determine the best path for data packets to travel from their source to their destination. Routers use IP addresses to make decisions about where to forward packets so that they reach the correct destination. The network layer of the OSI model, where IP operates, is responsible for this routing process123.
The other options listed do not facilitate routing in the same way:
Physical (A) and MAC (D) addresses are used at the data link layer to deliver packets on the same local network.
Transport (B) refers to the transport layer, which is responsible for end-to-end communication and data flow control but does not route packets over an IP network.

Straight-through cables are the most common type of Ethernet cable. They're used to connect dissimilar devices, such as a laptop to a router or a switch to a router. The internal wiring of the cable connects the transmit pins on one end to the receive pins on the other end, and vice versa.
Crossover cables were historically necessary to connect similar devices (e.g., router to router, or switch to switch). Modern devices often have auto MDI-X capabilities, allowing them to automatically detect and adjust to straight-through or crossover connections as needed.
Rollover cables have a reversed pinout and are primarily used for console access into Cisco routers and switches.
Fiber cables use fiber optic technology for high-speed, long-distance connectivity.
Reference:
Cisco Networking Academy: Introduction to Networks Course

Section: General Networking Knowledge