Online Access Free Cisco.200-301.v2021-10-11.q225 Practice Test (Page 2)

200-301 Exam Question 1

R1 has learned route 192.168.12.0/24 via IS-IS, OSPF, RIP, and Internal EIGRP.
Under normal operating conditions, which routing protocol is installed in the routing table?

A.IS-IS

B.RIP

C.OSPF

D.Internal EIGRP

200-301 Exam Question 2

Which two actions influence the EIGRP route selection process? (Choose two)

A.The router calculates the reported distance by multiplying the delay on the exiting Interface by 256.

B.The router calculates the best backup path to the destination route and assigns it as the feasible successor.

C.The router calculates the feasible distance of all paths to the destination route

D.The advertised distance is calculated by a downstream neighbor to inform the local router of the bandwidth on the link

E.The router must use the advertised distance as the metric for any given route

200-301 Exam Question 3

RIPV2

- Router R1connects the main office to internet, and routers R2and R3are internal routers
- NAT is enabled on Router R1
- The routing protocol that is enabled between R1, R2 and R3 is RIPv2
- R1 sends default route into RIPv2 for internal routers to forward internet traffic to R1
- Server1 and Server 2 are placed in VLAN 100 and 200 respectively, and are still running on stick Configuration with router R2.
You have console access on R1, R2, R3 and L2SW1 devices.
Use only show commands to troubleshoot the issues.
Server1 and Server2 are unable to communicate with the rest of the network. Your initial check with system administrators shows that IP address settings are correctly configured on the server side.
What could be an issue?

A.The Trunk is not configured on the L2SW1 switch.

B.The Router is missing subinterface configuration.

C.The VLAN encapsulation is misconfigured on the router subinterfaces.

D.The IP address is misconfigured on the primary router interface.