Online Access Free Cisco.200-301.v2022-06-20.q190 Practice Test (Page 31)

200-301 Exam Question 146

Which technology allows for multiple operating systems to be run on a single host computer?

A.server visualization

B.network port ID visualization

C.virtual routing and forwarding

D.virtual device contexts

200-301 Exam Question 147

Refer to the exhibit.

The entire contents of the MAC address table are shown. Sales-4 sends a data frame to Sales-1.

What does the switch do as it receives the frame from Sales-4?

A.Perform a lookup in the MAC address table and discard the frame due to a missing entry.

B.Insert the source MAC address and port into the forwarding table and forward the frame to Sales-1.

C.Map the Layer 2 MAC address to the Layer 3 IP address and forward the frame.

D.Flood the frame out of all ports except on the port where Sales-1 is connected.

200-301 Exam Question 148

Refer to the exhibit.

A router reserved these five routes from different routing information sources.
Which two routes does the router install in its routing table? (Choose two)

A.EIGRP route 10.0.0.1/32

B.OSPF route 10.0.0.0/16

C.OSPF route 10.0.0.0/30

D.iBGP route 10.0.0.0/30

E.RIP route 10.0.0.0/30

200-301 Exam Question 149

Which two actions influence the EIGRP route selection process? (Choose two)

A.The router calculates the reported distance by multiplying the delay on the exiting Interface by 256.

B.The router calculates the best backup path to the destination route and assigns it as the feasible successor.

C.The router calculates the feasible distance of all paths to the destination route

D.The advertised distance is calculated by a downstream neighbor to inform the local router of the bandwidth on the link

E.The router must use the advertised distance as the metric for any given route

200-301 Exam Question 150

Refer to the exhibit.

R5 is the current DR on the network, and R4 is the BDR. Their interfaces are flapping, so a network engineer wants the OSPF network to elect a different DR and BDR. Which set of configurations must the engineer implement?
A)