200-301 Exam Question 31
Refer to the exhibit.
Which two configurations must the engineer apply on this network so that R1 becomes the DR? (Choose two.) A)
B)
C)
D)
E)
Which two configurations must the engineer apply on this network so that R1 becomes the DR? (Choose two.) A)
B)
C)
D)
E)
200-301 Exam Question 32
Refer to Exhibit.
An engineer is configuring the NEW York router to reach the Lo1 interface of the Atlanta router using interface Se0/0/0 as the primary path. Which two commands must be configured on the New York router so that it can reach the Lo1 interface of the Atlanta router via Washington when the link between New York and Atlanta goes down? (Choose two)
An engineer is configuring the NEW York router to reach the Lo1 interface of the Atlanta router using interface Se0/0/0 as the primary path. Which two commands must be configured on the New York router so that it can reach the Lo1 interface of the Atlanta router via Washington when the link between New York and Atlanta goes down? (Choose two)
200-301 Exam Question 33
What are two descriptions of three-tier network topologies? (Choose two)
200-301 Exam Question 34
Refer to the exhibit.
Refer to the exhibit. All routers in the network are configured R2 must be the DR. After the engineer connected the devices, R1 was elected as the DR. Which command sequence must be configure on R2 to Be elected as the DR in the network?
Refer to the exhibit. All routers in the network are configured R2 must be the DR. After the engineer connected the devices, R1 was elected as the DR. Which command sequence must be configure on R2 to Be elected as the DR in the network?
200-301 Exam Question 35
Refer to the exhibit.
What must be configured to enable 802.11w on the WLAN?
What must be configured to enable 802.11w on the WLAN?