A port security violation has occurred on a switch port due to the maximum MAC address count being exceeded. Which command must be configured to increment the security-violation count and forward an SNMP trap?

Refer to the exhibit.

Drag and drop the networking parameters from the left onto the correct values on the right.

NIC vendor OUI -> 00:0C:22 NIC MAC address -> 00:0C:22:83:79:A3 default gateway -> 192.168.1.193 host IP address -> 192.168.1.200 subnet mask -> 255.255.255.192 The "ip route" and "ip addr show eth1" are Linux commands. + "ip route": display the routing table + "ip addr show eth1": get depth information (only on eth1 interface) about your network interfaces like IP Address, MAC Address information

Refer to the exhibit.

Which route type is configured to reach the internet?

Refer to Exhibit.

Which action do the switches take on the trunk link?

Which value is included in the initial TCP SYN message?