Refer to the exhibit.

An extended ACL has been configured and applied to router R2 The configuration failed to work as intended Which two changes stop outbound traffic on TCP ports 25 and 80 to 10.0.20 0 26 from the 10.0.10 0/26 subnet while still allowing all other traffic? (Choose two )

Which two minimum parameters must be configured on an active interface to enable OSPFv2 to operate?
(Choose two)

A network engineer must create a diagram of a multivendor network. Which command must be configured on the Cisco devices so that the topology of the network can be mapped?

Refer to the exhibit.

A new VLAN and switch are added to the network. A remote engineer configures OldSwitch and must ensure that the configuration meets these requirements:
* accommodates current configured VLANs
* expands the range to include VLAN 20
* allows for IEEE standard support for virtual LANs
Which configuration on the NewSwitch side of the link meets these requirements?

Refer to the exhibit.

An engineer is configuring the router to provide static NAT for the webserver Drag and drop the configuration commands from the left onto the letters that correspond to its position in the configuration on the right.