Online Access Free Cisco.200-301.v2025-11-10.q556 Practice Test (Page 53)

200-301 Exam Question 256

Which EtherChannel mode must be configured when using LAG on a WLC?

A.passive

B.active

C.on

D.auto

200-301 Exam Question 257

A network engineer must configure two new subnets using the address block 10 70 128 0/19 to meet these requirements:
* The first subnet must support 24 hosts
* The second subnet must support 472 hosts
* Both subnets must use the longest subnet mask possible from the address block Which two configurations must be used to configure the new subnets and meet a requirement to use the first available address in each subnet for the router interfaces? (Choose two )

A.interface vlan 4722
ip address 10.70.133.17 255.255.255.192

B.interface vlan 1148
ip address 10.70.148.1 255.255.254.0

C.interface vlan 1234
ip address 10.70.159.1 255.255.254.0

D.interface vlan 155
ip address 10.70.155.65 255.255.255.224

E.interface vlan 3002
ip address 10.70.147.17 255.255.255.224

200-301 Exam Question 258

A user configured OSPF and advertised the Gigabit Ethernet interface in OSPF By default, which type of OSPF network does this interface belong to?

A.point-to-multipoint

B.point-to-point

C.broadcast

D.nonbroadcast

200-301 Exam Question 259

When OSPF learns multiple paths to a network, how does it select a route?

A.It multiple the active K value by 256 to calculate the route with the lowest metric.

B.It divides a reference bandwidth of 100 Mbps by the actual bandwidth of the existing interface to calculate the router with the lowest cost.

C.For each existing interface, it adds the metric from the source router to the destination to calculate the route with the lowest bandwidth.

D.It count the number of hops between the source router and the destination to determine the router with the lowest metric

200-301 Exam Question 260

What is a reason to implement LAG on a Cisco WLC?

A.Increase the available throughput on the link.

B.Increase security by encrypting management frames

C.Allow for stateful failover between WLCs

D.Enable the connected switch ports to use different Layer 2 configurations

Other Version: 1513Cisco.200-301.v2026-03-24.q557; 2053Cisco.200-301.v2025-11-24.q467; 2616Cisco.200-301.v2025-07-30.q482; 2605Cisco.200-301.v2025-02-11.q320; 4742Cisco.200-301.v2024-05-26.q999; 2254Cisco.200-301.v2023-11-23.q374; 2601Cisco.200-301.v2023-07-05.q357; 3475Cisco.200-301.v2023-03-30.q402; 2624Cisco.200-301.v2023-03-18.q213; 3840Cisco.200-301.v2023-02-06.q262; 5909Cisco.200-301.v2022-08-20.q196; 11763Cisco.200-301.v2022-06-29.q194; 7990Cisco.200-301.v2022-06-20.q190; 1897Cisco.200-301.v2022-05-02.q75; 5767Cisco.200-301.v2022-02-16.q198; 5743Cisco.200-301.v2021-10-11.q225; 58Cisco.Actualtestpdf.200-301.v2021-08-30.by.len.222q.pdf

Latest Upload: 129F5.F5CAB5.v2026-06-22.q29; 129Juniper.JN0-650.v2026-06-22.q31; 151Salesforce.Plat-Admn-201.v2026-06-22.q72; 164VMware.3V0-21.25.v2026-06-20.q29; 169Microsoft.AB-731.v2026-06-19.q23; 326IIA.IIA-CIA-Part2.v2026-06-19.q308; 206DAMA.MD-1220.v2026-06-19.q66; 231ISTQB.CT-AI.v2026-06-18.q68; 380IIA.IIA-CIA-Part3.v2026-06-17.q220; 232WGU.Introduction-to-IT.v2026-06-17.q67

200-301 Exam Question 256

200-301 Exam Question 257

200-301 Exam Question 258

200-301 Exam Question 259

200-301 Exam Question 260

Download PDF File