Refer to the exhibit. VLAN 23 is being implemented between SW1 and SW2. The command show interface ethernet0/0 switchport has been issued on SW1. Ethernet0/0 on SW1 is the uplink to SW2. Which command when entered on the uplink interface allows PC 1 and PC 2 to communicate without impact to the communication between PC 11 and PC 12?

Which two must be met before SSH can operate normally on a Cisco IOS switch? (Choose two)

By default, how does EIGRP determine the metric of a route for the routing table?

How does automation affect network management processes?

Refer to the exhibit. A network engineer started to change default settings on SW1 to allow remote access and has entered the following in the configuration mode:
SW1(config)#line vty 0 15
SW1(config-line)#password Labtest32!
Which set of commands are needed to allow only SSH access and hide passwords in the running configuration?