Online Access Free Cisco.300-410.v2022-08-13.q115 Practice Test (Page 23)

300-410 Exam Question 106

Exhibit:

An engineer configured R2 and R5 as route reflectors and noticed that not all routes are sent to R1 to advertise to the eBGP peers. Which iBGP routers must be configured as route reflectors to advertise all routes to restore reachability across all networks?

A.R1 and R4

B.R1 and R5

C.R4 and R5

D.R2 and R5

300-410 Exam Question 107

Refer to the exhibit.

An engineer configures DMVPN and receives the hub location prefix of 10.1.1.0724 on R2 and R3 The R3 prefix of 10 1.3.0/24 is not received on R2. and the R2 prefix 10.1,2.0/24 is not received on R3. Which action reserves the issue?

A.Split horizon prevents the routes from being advertised between spoke routers it should be disabled with the no ip split-horizon eigrp 10 command on the Gi0/0 interface of R1.

B.There is no spoke-to-spoke connection DMVPN configuration should be modified to enable a tunnel connection between R2 and R3 and neighbor relationship confirmed by use of the show ip eigrp neighbor command

C.Split horizon prevents the routes from being advertised between spoke routers it should be disabled with the command no ip split-horizon eigrp 10 on the tunnel interface of R1

D.There is no spoke-to-spoke connection DMVPN configuration should be modified with a manual neighbor relationship configured between R2 and R3 and confirmed bb use of the show ip eigrp neighbor command.

300-410 Exam Question 108

Refer to the exhibit.

The network administrator can see the DHCP discovery packet in R1. but R2 is not replying to the DHCP request. The R1 related interface is configured with the DHCP helper address. If the PC is directly connected to the FaO/1 interface on R2, the DHCP server assigns as IP address from the DHCP pool to the PC. Which two commands resolve this issue? (Choose two.)

A.ip dhcp relay information trust-all command on R2

B.ip dhcp option 82 command on R2

C.service dhcp command on R1

D.ip dhcp relay information enable command on R1

E.service dhcp-relay command on R1

300-410 Exam Question 109

Refer to the exhibit.

An engineer is trying to block the route to 192.168.2.2 from the routing table by using the configuration that is shown. The route is still present in the routing table as an OSPF route. Which action blocks the route?

A.Use an extended access list instead of a standard access list.

B.Add this statement to the route map: route-map RM-OSPF-DL deny 20.

C.Use a prefix list instead of an access list in the route map.

D.Change sequence 10 in the route-map command from permit to deny.

300-410 Exam Question 110

Refer to Exhibit.

PC2 is directly connected to R1. A user at PC2 cannot Telnet to 2001:db8:a:b::10. The user can ping
2001:db8:a:b::10 and receive DHCP-related information from the DHCP server. Which action resolves the issue?

A.Remove sequence 20 and put it back as sequence 45.

B.Remove sequence 40 and put it back as sequence 15.

C.Remove sequence 10 and put it back as sequence 25.

D.Remove sequence 30 and put it back as sequence 5.

Other Version: 1138Cisco.300-410.v2026-02-04.q370; 1933Cisco.300-410.v2024-01-03.q227; 2127Cisco.300-410.v2023-02-14.q151; 2749Cisco.300-410.v2022-08-11.q99; 3198Cisco.300-410.v2022-07-18.q102; 4903Cisco.300-410.v2022-07-02.q117; 2411Cisco.300-410.v2022-06-24.q106; 66Cisco.Real4prep.300-410.v2022-06-08.by.lisa.285q.pdf; 7017Cisco.300-410.v2022-02-25.q285; 5658Cisco.300-410.v2021-10-09.q161; 91Cisco.Itpass4sure.300-410.v2021-09-03.by.afra.234q.pdf

Latest Upload: 123Microsoft.AB-731.v2026-06-19.q23; 246IIA.IIA-CIA-Part2.v2026-06-19.q308; 154DAMA.MD-1220.v2026-06-19.q66; 153ISTQB.CT-AI.v2026-06-18.q68; 246IIA.IIA-CIA-Part3.v2026-06-17.q220; 167WGU.Introduction-to-IT.v2026-06-17.q67; 219CompTIA.220-1202.v2026-06-16.q110; 140TheInstitutes.CPCU-500.v2026-06-16.q25; 220ACAMS.CAMS7-CN.v2026-06-16.q170; 278CBIC.CIC.v2026-06-15.q123

300-410 Exam Question 106

300-410 Exam Question 107

300-410 Exam Question 108

300-410 Exam Question 109

300-410 Exam Question 110

Download PDF File