Online Access Free Cisco.300-410.v2023-02-14.q151 Practice Test (Page 15)

300-410 Exam Question 66

What are two characteristics of IPv6 Source Guard? (Choose two.)

A.requires IPv6 snooping on Layer 2 access or trunk ports

B.used in service provider deployments to protect DDoS attacks

C.requires the user to configure a static binding

D.requires that validate prefix be enabled

E.recovers missing binding table entries

300-410 Exam Question 67

A network administrator added a new spoke site with dynamic IP on the DMVPN network. Which configuration command passes traffic on the DMVPN tunnel from the spoke router?

A.ip nhrp registration dynamic

B.ip nhrp registration no-unique

C.ip nhrp registration ignore

D.ip nhrp registration no-registration

300-410 Exam Question 68

Refer to the exhibit.

An engineer configured IP SLA on R1 to avoid the ISP link flapping problem. but it is not working as designed IP SLA should wait 30 seconds before switching traffic to a secondary connection and then revert to the primary link after waning 20 seconds, when the primary link is available and stabilized. Which configuration resolves the issue?

A.R1(config)#ip sla 700
R1(config-ip-sla)#delay down 30 up 20

B.R1(config)#ip sla 700
R1(config-ip-sla)#delay down 20 up 30

C.R1(config)#track 700 ip sla 700
R1(config-track)#delay down 30 up 20

D.R1(config)#track 700 ip sla 700
R1(config-track)#delay down 20 up 30

300-410 Exam Question 69

An administrator attempts to download the pack NBAR2 file using TFTP from the CPE router to another device over the Gi0/0 interface. The CPE is configured as below:

The transfer fails. Which action resolves the issue?

A.Make the permit udp any eq tftp any entry the last entry in the WAN ACL.

B.Change the WAN ACL to permit the UDP port 69 to allow TFTP

C.Shorten the file name to the 8+3 naming convention.

D.Change the WAN ACL to permit the entire UDP destination port range

300-410 Exam Question 70

What is a prerequisite for configuring BFD?

A.All routers in the path between two BFD endpoints must have BFD enabled.

B.To use BFD with BGP, the timers 3 9 command must first be configured in the BGP routing process.

C.Jumbo frame support must be configured on the router that is using BFD.

D.Cisco Express Forwarding must be enabled on all participating BFD endpoints.

Other Version: 1165Cisco.300-410.v2026-02-04.q370; 1960Cisco.300-410.v2024-01-03.q227; 4421Cisco.300-410.v2022-08-13.q115; 2763Cisco.300-410.v2022-08-11.q99; 3205Cisco.300-410.v2022-07-18.q102; 4952Cisco.300-410.v2022-07-02.q117; 2425Cisco.300-410.v2022-06-24.q106; 66Cisco.Real4prep.300-410.v2022-06-08.by.lisa.285q.pdf; 7030Cisco.300-410.v2022-02-25.q285; 5685Cisco.300-410.v2021-10-09.q161; 91Cisco.Itpass4sure.300-410.v2021-09-03.by.afra.234q.pdf

Latest Upload: 128F5.F5CAB5.v2026-06-22.q29; 129Juniper.JN0-650.v2026-06-22.q31; 151Salesforce.Plat-Admn-201.v2026-06-22.q72; 163VMware.3V0-21.25.v2026-06-20.q29; 169Microsoft.AB-731.v2026-06-19.q23; 323IIA.IIA-CIA-Part2.v2026-06-19.q308; 206DAMA.MD-1220.v2026-06-19.q66; 230ISTQB.CT-AI.v2026-06-18.q68; 376IIA.IIA-CIA-Part3.v2026-06-17.q220; 232WGU.Introduction-to-IT.v2026-06-17.q67

300-410 Exam Question 66

300-410 Exam Question 67

300-410 Exam Question 68

300-410 Exam Question 69

300-410 Exam Question 70

Download PDF File