Refer to the exhibit. Router DHCP is configured to lease IPv4 and IPv6 addresses to clients on ALS1 and ALS2. Clients on ALS2 receive IPv4 and IPv6 addresses. Clients on ALS1 receive IPv4 addresses. Which configuration on DSW1 allows clients on ALS1 to receive IPv6 addresses?

You are configuring Netflow on various network elements in order to gain visibility into the traffic types used. How many export destinations can this Network data be sent to?

Refer to the exhibit. Which set of commands restore reachability to loopback0?

Refer to the exhibit. The Customer Edge rouler wants to use AS 100 as the preferred ISP for all external routes and ISP-2 as a backup.


After this configuration, all the backup routes have disappeared from the BGP table on the Customer Edge router. Which set of configurations resolves the issue on the Customer Edge router?

Refer to the exhibit. A network administrator must configure DMVPN tunnels between the hub and spoke with dynamic spoke-to-spoke tunnel capabilities using EIGRP.
Which tunnel interface command must the network administrator configure to establish an EIGRP peer?
crypto isakmp policy 1
authentication pre-share
crypto isakmp key cisco047 address 0.0.0.0
crypto ipsec transform-set trans2 esp-des esp-md5-hmac
mode transport
crypto ipsec profile vpnprof
set transform-set trans2
interface Tunnel0
bandwidth 1000
ip address 10.0.0.1 255.255.255.0
ip mtu 1400
ip nhrp authentication donttell
ip nhrp map multicast dynamic
ip nhrp network-id 93
ip nhrp holdtime 300
no ip split-horizon eigrp 1
ip ospf-mss 1360
delay 1000
tunnel source Gigabitethernet 0/0
tunnel mode gre multipoint
tunnel key 100000
tunnel protection ipsec profile vpnprof
interface FastEthernet0/0
ip address 172.17.0.1 255.255.255.0
interface FastEthernet0/1
ip address 192.168.0.1 255.255.255.0
router eigrp 1
network 10.0.0.0 255.255.255.0
network 192.168.0.0 0.0.0.255