300-420 Exam Question 71
Refer to the exhibit.
EIGRP has been configured on all links. The spoke nodes have been configured as EIGRP stubs, and the WAN links to R3 have higher bandwidth and lower delay than the links to R4. When a link failure occurs at the R1-R2 link, what happens to traffic on R1 that is destined for a subnet attached to R2?
EIGRP has been configured on all links. The spoke nodes have been configured as EIGRP stubs, and the WAN links to R3 have higher bandwidth and lower delay than the links to R4. When a link failure occurs at the R1-R2 link, what happens to traffic on R1 that is destined for a subnet attached to R2?
300-420 Exam Question 72
Which queuing structure is used on SD-WAN Edge routers?
300-420 Exam Question 73
An engineer is designing a multicast network for a company specializing in VoD content.
Receivers are across the Internet, and for performance reasons, the multicast framework must be close to the receivers within each AS. For high availability, if the sources in one AS are no longer available, the receivers of that AS must be able to receive the VoD content from the sources in another AS. Which feature must the design include?
Receivers are across the Internet, and for performance reasons, the multicast framework must be close to the receivers within each AS. For high availability, if the sources in one AS are no longer available, the receivers of that AS must be able to receive the VoD content from the sources in another AS. Which feature must the design include?
300-420 Exam Question 74
An engineer uses Postman and YANG to configure a router with:
* OSPF process ID 200
* network 172.16.10.128/26 enabled for Area 0
Which get-config reply verifies that the model set was designed correctly?
* OSPF process ID 200
* network 172.16.10.128/26 enabled for Area 0
Which get-config reply verifies that the model set was designed correctly?
300-420 Exam Question 75
What is the purpose of a control plane node in a Cisco SD-Access network fabric?