An SNR (Signal-to-Noise Ratio) less than 15 dB within the cell boundary during an AP-on-a-stick survey indicates that there is interference affecting the AP's signal. This interference could be from another signal source that is reducing the quality of the connection, despite the signal strength being within the acceptable cell boundary of -67 dBm.

When a Wireless LAN Controller (WLC) SSO is set up between two WLCs in a service provider network, and there is a failover, the secondary WLC should ideally support the same client count as the primary. If only about half of the original client count is showing on the secondary WLC post-failover, it suggests that the WLCs had not completed the database synchronization before the primary WLC failed. This incomplete sync would result in a loss of client information, leading to a reduced client count on the secondary WLC.

Link Aggregation Group (LAG) allows multiple physical ports to be combined into a single logical channel. In the scenario where only one Cisco 9800-40 WLC is available and high availability is required, LAG can be used to manage port redundancy and perform load balancing between APs transparently. This ensures that if one cable fails, the others can continue to carry the traffic without any perceived downtime

Creating a mobility group requires that all Wireless LAN Controllers (WLCs) share the same mobility group name. This allows them to recognize each other as peers and participate in client mobility events. The WLCs must be defined as peers in each other's static mobility members list to facilitate inter-controller communication and roaming.