Online Access Free Cisco.300-510.v2021-10-07.q87 Practice Test (Page 3)

300-510 Exam Question 6

Refer to the exhibit.

While configuring router 2 with all the default values, a network engineer cannot see any route received in router 1. How should the engineer solve the issue?

A.Set up a priority different than 0 in the interface.

B.Modify the router ID to be the interface IP on the serial.

C.Set the network type in S1/0 to point-to-point.

D.Modify the IP address or mask of the interface to a valid one.

300-510 Exam Question 7

Refer to the exhibit.

After you applied these configurations to routers R1 and R2, the two devices could not form a neighbor relationship. Which reason for the problem is the most likely?

A.The two routers have different IS-types.

B.The two routers have the same network ID.

C.The two routers cannot authenticate with one another.

D.The two routers have the same area ID.

300-510 Exam Question 8

Refer to the exhibit.

An engineer has successfully fixed BGP peering issue. R1 has an established eBGP peering with R2 and R3. Which mechanism should the engineer apply in order to steer the traffic correctly?

A.The MED attribute can be applied on R2 to influence R1 to use it as the primary path.

B.The weight attribute can be applied on R2 to influence AS 65513 to use AS 65515 as the primary path.

C.The local preference attribute can be applied on R3 to influence AS 65513 to use AS 65515 as the secondary path.

D.The IGP metric can be manipulated on R1 to allow traffic to be load balanced between R2 and R3.

300-510 Exam Question 9

Refer to the exhibit.

An engineer has configured all routers in the environment to run IS-IS Level 1 and Level 2 routing. The engineer wants traffic from R1 to R5 to pass via R2. but IS-IS routing has calculated the best path via R4. Which action corrects the problem?

A.Set the link metric on R2 for the links from router R2 to routers R3 and R4 to 30 or more.

B.Configure routers R1, R4, and R5 for Level 2 routing only.

C.Set the link metric for the link from router R1 to router R4 to 30 or more.

D.Configure routers R1, R2, and R5 for Level 1 routing only.