Online Access Free Cisco.300-510.v2022-03-04.q145 Practice Test (Page 28)

300-510 Exam Question 131

Refer to the exhibit.

An engineer is addressing an IS-IS design issue which is running within the topology. All links are running on FastEthernet, except the link between R5 and R4, which is Gigabit Ethernet. Which statement about the design is true?

A.R4 prefer to reach R5 using R1 as the next hop

B.R1 prefer to use R5 as the next hop to reach R4

C.R5 prefers to use R4 as the next hop for all routes

D.All links have equal cost if the default metric is used

300-510 Exam Question 132

Refer to the exhibit.

After troubleshooting BGP traffic steering issue, which action did the network operator take to achieve the correct effect of this configuration?

A.Routes that have passed through AS 65517 have the local preference set to 150.

B.Routes that have originated through AS 65517 have the local preference set to 150.

C.Routes directly attached to AS 65517 have the local preference set to 150.

D.Routes that have passed through AS 65517 have the local preference set to 150 and the traffic is denied.

300-510 Exam Question 133

Refer to the exhibit.

While configuring router 2 with all the default values, a network engineer cannot see any route received in router 1. How should the engineer solve the issue?

A.Set up a priority different than 0 in the interface.

B.Modify the router ID to be the interface IP on the serial.

C.Modify the IP address or mask of the interface to a valid one.

D.Set the network type in S1/0 to point-to-point.

300-510 Exam Question 134

Refer to the exhibit. What is the relationship between Router 1 and Router 2?

A.Router 2 is the head-end router in an SR-TE tunnel, and it is learning topology of the network from the PCE enabled on Router 1.

B.Router 1 centrally learns the topology of the network to aid in SR-TE path selection, and Router 2 is a node that feeds Router 1 topology information.

C.Router 1 and Router 2 are participating in SR-TE tunnels and are both head-end routers.

D.Router 1 and Router 2 centrally learn the topology of the network to aid in SR-TE path selection for peers.

300-510 Exam Question 135

After an engineer configures BGP in R1, it starts receiving this message
*Jun 29 13:30:50.122: %BGP-5-ADJCHANGE: neighbor 192.168.10.1 Down User reset Jun 29 13:30:52.341: %BGP-3-NOTIFICATION: sent to neighbor 192.168.10.1 2/6 (unacceptable hold time) 0 bytes Which action makes the peering come back up again?

A.Set up a minimum hold-down timer higher.

B.Set up a hold-down timer higher.

C.Make a soft reset to the peer.

D.Set up a hello timer higher.

Other Version: 912Cisco.300-510.v2025-08-02.q115; 938Cisco.300-510.v2024-03-25.q137; 1356Cisco.300-510.v2023-05-05.q72; 1031Cisco.300-510.v2023-03-06.q55; 92Cisco.Troytecdumps.300-510.v2022-03-02.by.virginia.145q.pdf; 2256Cisco.300-510.v2021-10-07.q87; 81Cisco.Exam4docs.300-510.v2021-08-23.by.sylvia.96q.pdf

Latest Upload: 117ISTQB.CT-AI.v2026-06-18.q68; 231IIA.IIA-CIA-Part3.v2026-06-17.q220; 148WGU.Introduction-to-IT.v2026-06-17.q67; 195CompTIA.220-1202.v2026-06-16.q110; 129TheInstitutes.CPCU-500.v2026-06-16.q25; 207ACAMS.CAMS7-CN.v2026-06-16.q170; 225CBIC.CIC.v2026-06-15.q123; 144Peoplecert.ITIL-4-Specialist-High-velocity-IT.v2026-06-15.q16; 245HashiCorp.Terraform-Associate-004.v2026-06-15.q126; 153Peoplecert.ITILFNDv5.v2026-06-15.q26

300-510 Exam Question 131

300-510 Exam Question 132

300-510 Exam Question 133

300-510 Exam Question 134

300-510 Exam Question 135

Download PDF File