Online Access Free Cisco.300-510.v2025-08-02.q115 Practice Test (Page 17)

300-510 Exam Question 76

Refer to the exhibit.

A regional service provider provides connectivity for several midsize businesses that run mission-critical applications between multiple offices connected via PE 1 and PE2 Links throughout the service provider network are connected using shared resources and an SR-TE tunnel is in use to route traffic over different paths depending on congestion policies The networking team must implement SR updates to reduce downtime in the event of a link failure. Which action must the team take to meet the requirements?

A.Implement VRFs to segment the network and avoid large-scale network outages when a link fails

B.Implement SRLG protection to identify a post-convergence backup path

C.Implement targeted LDP neighbors to prevent unwanted LDP relationships from forming

D.Implement BGP timers to support immediate reconvergence when the BGP neighbor relationship status changes.

300-510 Exam Question 77

Refer to the exhibit.

An engineer is troubleshooting connectivity issues on the MPLS core network. A customer connected through R4 cannot reach the OSPF domain on R5. While checking the routing table of R1, the engineer cannot see all the routes from R3 and R5. Which task must the engineer perform so that R4 is able to reach R5?

A.Enable route filtering between routers R1 and R3.

B.Enable OSPF on the Area-0 routers and configure MP-BGP between routers R1 and R3.

C.Enable MP-BGP peering on routers R1. R3, R4, and R5.

D.Enable OSPF peering and configure route redistribution between routers R4 and R1.

300-510 Exam Question 78

Which difference must an engineer consider when Implementing Inter-domain and Intra-domain multicast routing on the network?

A.Intra-domain routing allows the service provider to control incoming and outgoing multicast data streams on its network, but inter-domain routing limits the service provider's control.

B.Intra-domain routing is dependent on the RP router within the same SP network, but inter-domain routing reduces the dependency on the other SP network.

C.Inter-domain routing supports policy routing to connect different multicast domains using PIM.SM, but intra-domain routing supports policy routing using PIM-SM only within a single domain.

D.Intra-domain routing uses the PIM and MBGP protocols for multicast routing, but inter-domain routing must use PIM.SSM or MSDP.

300-510 Exam Question 79

Which lag command is used within route-map to redistribute routes that match with routes tagged with the specified tag numbers?

A.match routing tag

B.match all tag

C.match route tag

D.match tag

300-510 Exam Question 80

Refer to the exhibit Router 1 resides in a different data center than Rouler 2 and Router 3. Router 1 is running the IS-IS routing protocol, and it is preconfigured with LDP and segment routing Which configuration must the engineer apply under router isis 111 on Router 1 to implement Tl-LFA on the link to Router 2 without disrupting traffic to Router 3?