Online Access Free Cisco.300-510.v2025-08-02.q115 Practice Test (Page 7)

300-510 Exam Question 26

Which feature provides service independence in service provider networks?

A.node SID that identifies the network device

B.binding SID that is used to stitch different domains

C.prefix SID that contains router hops toward the destination

D.adjacency SID that represents a path between the routers

300-510 Exam Question 27

Which keyword is used with the match route-type command to redistribute the external BGP and IGP routes using route map?

A.match route-type nssa-external

B.match route-type type-1

C.match route-type type-2

D.match route-type external

300-510 Exam Question 28

What does conditional matching operate with RPL?

A.The matching identifies a group of routes that are removed from the routing table when the administrator defined tags match

B.The matching identifies tags that are placed on routes from neighboring autonomous systems and drops the routes if they are the same.

C.The matching identifies a set of criteria, and an action is taken based on whether the criteria are the same or different

D.The matching identifies interfaces that run the same routing protocol and manipulates data based on the routing rules

300-510 Exam Question 29

An engineer is troubleshooting slow performance issues on a customer's network after the last multicast configuration change was applied on it While checking the running configuration on the router the engineer notices there are many ip igmp join-group commands applied on several interfaces of the router which caused the high CPU utilization usage. What action must the engineer take to solve this issue?

A.Configure ip igmp static-group command on all interfaces

B.Remove ip igmp join-group command on all unnecessary interfaces

C.Configure all router interfaces to be process-switched by increasing the query interval

D.Remove unnecessary members from the IGMP group

300-510 Exam Question 30

Refer to the exhibit. A network engineer is configuring router R3 to handle multicast streams, but Host-2 cannot send subscriptions messages to the IPTV source. Which configuration must the engineer apply to router R3 so it passes the IPTV stream to Host-2?