Online Access Free Cisco.300-515.v2022-01-17.q65 Practice Test (Page 13)

300-515 Exam Question 56

Which is the primary function of a MPLS L3 VPN route target?

A.It uniquely identifies NLRIs that have the same numeric value.

B.It imports and exports identified routes into selected VRFs.

C.It supports QoS by classifying traffic by file type when it applies MPLS EXP bits to each packet.

D.It imports the external routes it identifies into VRFs that support Internet traffic

300-515 Exam Question 57

Refer to the exhibit.

Which statement describes the result of this configuration?

A.R1 redistributes BGP routes into the OSPF process of VRF custabc as E1 routes.

B.R1 redistributes BGP routes into the OSPF process of VRF custabc as OIA routes.

C.R1 mutually redistributes routes between BGP 65001 and the OSPF process of VRF custabc.

D.R1 redistributes BGP routes into the OSPF process of VRF custabc as E2 routes.

300-515 Exam Question 58

Refer to the exhibit.

Which statement about this configuration is true?

A.Router 1 has statically defined thresholds for data MDT.

B.Router 1 will accept multicast routes with a route-target of 12:1.

C.192.168.1.2 must be reachable by all routers participating in the mvpn-intranet MVRF.

D.The MVRF must be configured on each router on the customer and service provider networks.

300-515 Exam Question 59

The CTO of a company requires the support of a network consultant to deliver an MPLS solution without resigning to a certain degree of redundancy and scalability. Which solution effectively scales to hundreds or thousands of sites?

A.L2VPN with the broadcast traffic processed at the ingress PE.

B.L2VPN by encapsulating multiple frame formats with interworking.

C.L3VPN with direct LSP connectivity between all PEs.

D.L3VPN using a hierarchical topology of N-PEs and U-PEs.

300-515 Exam Question 60

Refer to the exhibit:

A network engineer is implementing an OSPF configuration Based on the output, which statement is true?

A.In the ospfv3 1 area 1 ipv4 command, area 0 must be configured instead of area 1.

B.OSPFv3 does not run for IPv4 on FastEthemet0/0 until IPv6 routing is enabled on the router and IPv6 is enabled on interface Fastfc.thernet0/0

C.IPv6 routing not enabled" is just an informational message and OSPFv3 runs for IPv4 on interface FastEthernet0/0 anyway

D.OSPFv3 cannot be configured for IPv4; OSPFv3 works only for IPv6.

Other Version: 1235Cisco.300-515.v2022-10-01.q87; 34Cisco.Actual4test.300-515.v2022-03-14.by.jay.65q.pdf; 1337Cisco.300-515.v2021-08-23.q62; 85Cisco.Ipassleader.300-515.v2021-08-12.by.fitch.65q.pdf

Latest Upload: 151CBIC.CIC.v2025-09-13.q75; 155Cisco.700-841.v2025-09-13.q131; 145SAP.C_ABAPD_2507.v2025-09-12.q56; 128SAP.C_TS452_2022.v2025-09-12.q83; 211ACSM.020-222.v2025-09-11.q48; 167VMware.5V0-31.23.v2025-09-10.q73; 138Oracle.1z0-915-1.v2025-09-10.q24; 174Citrix.1Y0-231.v2025-09-10.q87; 149SAP.C-THR85-2505.v2025-09-09.q29; 188Adobe.AD0-E727.v2025-09-09.q76

300-515 Exam Question 56

300-515 Exam Question 57

300-515 Exam Question 58

300-515 Exam Question 59

300-515 Exam Question 60

Download PDF File