300-610 Exam Question 76
Refer to the exhibit. An engineer is configuring a QoS policy with these requirements:
- Match-all AF11 traffic and set it to a DSCP value of 14.
- The committed rate must be 10 Mbps with a committed burst rate of
1000 ms.
- Drop any AF11 traffic that violates these settings.
- Any traffic other than af11 must have a DSCP value of 0.
The given class-map configuration already exists. Which solution must the engineer use to meet the requirements?
- Match-all AF11 traffic and set it to a DSCP value of 14.
- The committed rate must be 10 Mbps with a committed burst rate of
1000 ms.
- Drop any AF11 traffic that violates these settings.
- Any traffic other than af11 must have a DSCP value of 0.
The given class-map configuration already exists. Which solution must the engineer use to meet the requirements?
300-610 Exam Question 77
An engineer installs a B-Series server in a Cisco UCS chassis that contains a pair of UCS-IOM-2208XP I/O modules. The full bandwidth of the I/O module must be utilized.
Which two elements should be used in this environment? (Choose two.)
Which two elements should be used in this environment? (Choose two.)
300-610 Exam Question 78
An engineer must connect a storage array directly to an existing Cisco UCS Fabric Interconnect. The customer requires a solution that provides IP-based storage that does not need to be connected through an external switch Also, the operations team wants to have the ability to have direct access to the files stored on the storage array from their Linux hosts. Which storage technology meets these requirements?
300-610 Exam Question 79
An engineer must provide Layer 2 adjacency between data centers that are in two locations and separated by a routed network. The adjacency must be based on Cisco Nexus 7000 Series Switches. The solution must offload learning of host reachability information to the control plane to avoid excessive flood and learn congestion. Also the data center in one of the sites experiences a large volume of unknown unicast traffic that the solution must mitigate.
Which data center interconnect technology meets these requirements?
Which data center interconnect technology meets these requirements?
300-610 Exam Question 80
A company has several data centers with hundreds of Cisco UCS blade chassis. A network consultant plans to active Cisco Discovery Protocol to the servers to facilitate Layer 1 troubleshooting. For security reasons, the company wants to restrict the servers from sending different MAC addresses to the fabric interconnect after the MAC address from the first packet is learned. Which two policies be modified to support this design? (Choose two.)
