300-610 Exam Question 116
Drag and drop the feature descriptions from the left onto the correct UCS Fabric Interconnect modes on the right.


300-610 Exam Question 117
Refer to the exhibit. A Cisco engineer is configuring Cisco Nexus 7000 Series Switches. To simplify initial configuration verification and vPC+/HSRP troubleshooting, the engineer configures the primary vPC+ peer device with the FHRP active router highest priority. The primary FHRP device responds to ARP requests, even though the secondary vPC+ device also forwards the data traffic. Which configuration enables the Layer 3 connectivity from each vPC+ peer device?


300-610 Exam Question 118
The user traffic destined to all web servers located in the data center must pass first through a set of firewalls for deep packet inspection. A network architect must design the Cisco Intelligent Traffic Director (ITD) deployment that meets these requirements:
The firewalls are connected to a set of two Cisco Nexus switches to provide stateful handling of traffic.
The ITD service is provided for inside and outside segments of the firewall.
Which ITD deployment mode must be implemented to meet these requirements?
The firewalls are connected to a set of two Cisco Nexus switches to provide stateful handling of traffic.
The ITD service is provided for inside and outside segments of the firewall.
Which ITD deployment mode must be implemented to meet these requirements?
300-610 Exam Question 119
An engineer is implementing a storage area network where an NPV is used. The engineer notices that the servers in a storage farm are experiencing heavy traffic contention. The engineer needs to migrate traffic from heavily loaded server interfaces to interfaces with less load. When the new links are deployed, the existing traffic is not rebalanced as expected.
Which feature must be used to meet these requirements?
Which feature must be used to meet these requirements?
300-610 Exam Question 120
An engineer configured the OSPF protocol in the vPC topology. During the catastrophic failure of one of the vPC member switches, the traffic was routed to a black hole. This route was caused by the long convergence time caused by the delay of the vPC member switch reboot. After the failure, the engineer rebooted both switches, but the secondary switch powered on before the primary one. It caused all the vPCs to be shut down due to consistency-check violations.
Which two features must be used to prevent these situations from happening in the future? (Choose two.)
Which two features must be used to prevent these situations from happening in the future? (Choose two.)

