300-610 Exam Question 91
Which mode must be enabled on a Cisco UCS Fabric Interconnect to connect directly to a storage array?
300-610 Exam Question 92
Refer to the exhibit.

A customer runs an Online Transaction Processing (OLTP) application on Server1. The application generates a small number of transactions and requires low storage latency. Server2 is a backup server that performs backups twice a day During the backup window, the OLTP application experiences high-latency spikes that affect the application performance The customer must meet these requirements
*Maintain consistent low I/O latency for the OLTP server.
*Guarantee I/O throughput for the OLTP server during backup time
*Allow the customer to keep the existing hardware.
Which action must be taken to meet these requirements?

A customer runs an Online Transaction Processing (OLTP) application on Server1. The application generates a small number of transactions and requires low storage latency. Server2 is a backup server that performs backups twice a day During the backup window, the OLTP application experiences high-latency spikes that affect the application performance The customer must meet these requirements
*Maintain consistent low I/O latency for the OLTP server.
*Guarantee I/O throughput for the OLTP server during backup time
*Allow the customer to keep the existing hardware.
Which action must be taken to meet these requirements?
300-610 Exam Question 93
A engineer wants to eliminate the manual process of checking the system hardware and firmware against a specified hardware compatibility tool. The tool must be able to manage an extensive list of devices including cisco HyperFlex, MDS, and Nexus switches. The tool must manage hardware in multiple data centers so it should be deployed on public cloud infrastructure. Which tool meets these requirements?
300-610 Exam Question 94
An engineer is configuring a Cisco UCS Service Profile template for an environment that will host Windows servers Some of the servers require access to a Fibre Channel storage network The design requires the server HBA to send the maximum number of commands to a Fibre Channel disk using a single transmission Which action must be taken to meet these requirements?
300-610 Exam Question 95
An engineer configured the OSPF protocol in the vPC topology. During the catastrophic failure of one of the vPC the member switches, the traffic was routed to a black hole. This route was caused by the long convergence time caused by the delay of the of the vPC member switch reboot. After the failure, the engineer rebooted both switches, but the secondary switch powered on before the primary one. It caused all the vPCs to be shut down due to consistency-check violations. Which two features must be used to prevent these situations from happening in the future? (Choose two.)

