A.Recreate the guestshell

B.Reboot the guestshell

C.Reboot the switch

D.Resync the database

A.Configure the IP address on the interface.

B.Activate VLANs on the vPC.

C.Configure one of the switches as primary for the vPC.

D.Correct the configuration of the vPC peer link and the vPC peer keepalive.

E.Match the vPC domain ID between the two devices.

A.Configure an MTU size of 9000 on the appliance port.

B.Statically configure the target information in the Boot Policy.

C.Configure a QoS policy on the vNIC.

D.Set a connection timeout value of 250 in the iSCSI Adapter Policy.

A.1) Verify that the IOM firmware and Cisco UCS Manager are at different software levels
2) Verify that at least two physical cables between the IOM and fabric interconnect function properly.
3) Check for runtime link down status
4) Reseat the affected IOM.

B.1) Verify that the IOM firmware and Cisco UCS Manager are at the same software level.
2) Verify that at least one physical cable between the IOM and fabric interconnect functions properly.
3) Check for runtime link down status
4) Reseat the affected IOM.

C.1) Verify that the IOM firmware and Cisco UCS Manager are at the same software level.
2) Verify that at least two physical cables between the IOM and fabric interconnect function properly.
3) Check for runtime link down status.
4) Reseat the affected IOM.

D.1) Verify that the IOM firmware and Cisco UCS Manager are at different software levels.
2) Verify that at least one physical cable between the IOM and fabric interconnect functions properly.
3) Check for runtime link down status.
4) Reseat the affected IOM.

A.All connections must be reset before the new uplinks can be used.

B.Only new connections use the new uplinks automatically.

C.New and existing connections use the new uplinks automatically.

D.Paths must be defined before new connections can use the new uplinks.