300-625 Exam Question 1
A storage network engineer is implementing SAN telemetry for a SAN infrastructure using Cisco DCNM for SAN. Which command is used to check the session status for telemetry operation?
300-625 Exam Question 2
A storage administrator wants to enable NPV in a Fibre Channel edge switch. Which configuration is supported in this mode?
300-625 Exam Question 3
Refer to the exhibit.

What is the result of the configuration?

What is the result of the configuration?
300-625 Exam Question 4
A storage administrator is connecting two previously configured switches to make a single fabric. When the E Ports are connected, the administrator sees a ZONE MERGE FAILURE message referring to the zoneset for VSAN 10 on each switch. Which command should the administrator use to allow these switches to work together?
300-625 Exam Question 5
Refer to the exhibit.

Refer to the exhibit. A port channel has been configured between a Cisco MDS and a Cisco Fabric Interconnect switch. Which interface(s) in the port channel carry the control plane traffic?

Refer to the exhibit. A port channel has been configured between a Cisco MDS and a Cisco Fabric Interconnect switch. Which interface(s) in the port channel carry the control plane traffic?