While configuring FTD, a network engineer wants to ensure that traffic passing through the appliance does not require routing or Vlan rewriting. Which interface mode should the engineer implement to accomplish this task?

Which two considerations must be made when deleting and re-adding devices while managing them via Cisco FMC (Choose two).

An engineer is setting up a new Firepower deployment and is looking at the default FMC policies to start the implementation During the initial trial phase, the organization wants to test some common Snort rules while still allowing the majority of network traffic to pass Which default policy should be used?

An engineer is building a new access control policy using Cisco FMC. The policy must inspect a unique IPS policy as well as log rule matching. Which action must be taken to meet these requirements?

An engineer currently has a Cisco FTD device registered to the Cisco FMC and is assigned the address of
10.10.50.12. The organization is upgrading the addressing schemes and there is a requirement to convert the addresses to a format that provides an adequate amount of addresses on the network. What should the engineer do to ensure that the new addressing takes effect and can be used for the Cisco FTD to Cisco FMC connection?