Which EIGRP feature allows the use of leak maps?

Lab Simulation 4
Guidelines
This is a lab item in which tasks will be performed on virtual devices.
- Refer to the Tasks tab to view the tasks for this lab item.
- Refer to the Topology tab to access the device console(s) and perform the tasks.
- Console access is available for all required devices by clicking the device icon or using the tab(s) above the console window.
- All necessary preconfigurations have been applied.
- Do not change the enable password or hostname for any device.
- Save your configurations to NVRAM before moving to the next item.
- Click Next at the bottom of the screen to submit this lab and move to the next question.
- When Next is clicked, the lab closes and cannot be reopened.
Topology

Tasks
Implement VRRP between DISTRO-SW1 and DISTRO-SW2 on VLAN100 for hosts connected to ACCESS-SW1 to achieve these goals:
1. Configure group number 200 using the virtual IP address of 192.168.1.200/24.
2. Configure DISTRO-SW1 as the active router using a priority value of 200 and DISTRO-SW2 as the standby router.
3. DISTRO-SW1 and DISTRO-SW2 should exchange VRRP hello packets every 20 seconds.




DISTRO-SW2

High bandwidth utilization is occurring on interface Gig0/1 of a router. An engineer must identify the flows that are consuming the most bandwidth. Cisco DNA Center is used as a flow exporter and is configured with the IP address 192.168.23.1 and UDP port 23000. Which configuration must be applied to set NetFlow data export and capture on the router?

Refer to the exhibit. The administrator configures an ERSPAN session, but no packets are received on the destination host. Which action is required to complete the configuration?

Refer to the exhibit. After implementing the configuration, 172.20.20.2 stops replying to ICMP echos, but the default route fails to be removed. What is the reason for this behavior?