This segment has no designated router because it is a p2p network type." It is clearly seen on the output that this is a serial point to point link LOL which requires no DR/BDR. Also, a non- broadcast network type actually calls for a DR/BDR. Not sure what they were thinking.
OSPF recognizes the following network types:
Broadcast
Non-Broadcast
Point to Multipoint (Broadcast)
Point to Multipoint (Non-Broadcast)
Point to Point
Out of all of those possibilities, only Broadcast and Non-Broadcast form DRs and BDRs. The Broadcast and Non-Broadcast network types describe a multi-access network media, such as Ethernet. In this case OSPF requires that all routers on the same network segment have direct reachability both to the DR and BDR, otherwise the network will break.

802.11r Fast Transition (FT) Roaming is an amendment to the 802.11 IEEE standards. It is a new concept for roaming. The initial handshake with the new AP occurs before client roams to the target AP. Therefor it is called Fast Transition. 802.11r provides two methods of roaming:
+ Over-the-air: With this type of roaming, the client communicates directly with the target AP using IEEE 802.11 authentication with the Fast Transition (FT) authentication algorithm.
+ Over-the-DS (distribution system): With this type of roaming, the client communicates with the target AP through the current AP. The communication between the client and the target AP is carried in FT action frames between the client and the current AP and is then sent through the controller.
But both of these methods do not deal with legacy clients.
The 802.11k allows 11k capable clients to request a neighbor report containing information about known neighbor APs that are candidates for roaming.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/technotes/80211r-ft/b-
80211r-dg.html
IEEE 802.11v is an amendment to the IEEE 802.11 standard which describes numerous enhancements to wireless network management. One such enhancement is Network assisted Power Savings which helps clients to improve the battery life by enabling them to sleep longer.
Another enhancement is Network assisted Roaming which enables the WLAN to send requests to associated clients, advising the clients as to better APs to associate to. This is useful for both load balancing and in directing poorly connected clients.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/config- guide/b_wl_16_10_cg/802-11v.pdf Cisco 802.11r supports three modes:
+ Pure mode: only allows 802.11r client to connect
+ Mixed mode: allows both clients that do and do not support FT to connect
+ Adaptive mode: does not advertise the FT AKM at all, but will use FT when supported clients connect Therefore "Adaptive mode" is the best answer here.

https://www.cisco.com/c/en/us/support/docs/wireless/catalyst-9800-series-wireless- controllers/213920-central-web-authentication-cwa-on-cata.html#toc-hId-881505252