350-401 Exam Question 501
In which order of magnitude (time) is delay/latency measured when you use wide metrics in EIGRP?
350-401 Exam Question 502
You want to securely implement the Network Time Protocol (NTP) on your network. What two mechanisms are available to secure NTP? (Choose two.)
350-401 Exam Question 503
In a Cisco Catalyst switch equipped with two supervisor modules an administrator must temporally remove the active supervisor from the chassis to perform hardware maintenance on it.
Which mechanism ensure that the active supervisor removal is not disruptive to the network operation?
Which mechanism ensure that the active supervisor removal is not disruptive to the network operation?
350-401 Exam Question 504
If a VRRP master router fails, which router is selected as the new master router?
350-401 Exam Question 505
Lab Simulation 5
Guidelines
This is a lab item in which tasks will be performed on virtual devices.
- Refer to the Tasks tab to view the tasks for this lab item.
- Refer to the Topology tab to access the device console(s) and perform the tasks.
- Console access is available for all required devices by clicking the device icon or using the tab(s) above the console window.
- All necessary preconfigurations have been applied.
- Do not change the enable password or hostname for any device.
- Save your configurations to NVRAM before moving to the next item.
- Click Next at the bottom of the screen to submit this lab and move to the next question.
- When Next is clicked, the lab closes and cannot be reopened.
Topology
Tasks
Configure OSPF on all three routers according to the topology diagram to achieve these goals:
1. Enable OSPF on all interfaces using the network statement and match the network mask of each interface.
2. Ensure that all networks are advertised between the routers.
3. Ensure that all routers use OSPF process ID 1 and that the Lo0 interface is used for the router ID.
4. Configure OSPF MD5 authentication on every physical interface running OSPF using key 1 and the password ccnp321.
Guidelines
This is a lab item in which tasks will be performed on virtual devices.
- Refer to the Tasks tab to view the tasks for this lab item.
- Refer to the Topology tab to access the device console(s) and perform the tasks.
- Console access is available for all required devices by clicking the device icon or using the tab(s) above the console window.
- All necessary preconfigurations have been applied.
- Do not change the enable password or hostname for any device.
- Save your configurations to NVRAM before moving to the next item.
- Click Next at the bottom of the screen to submit this lab and move to the next question.
- When Next is clicked, the lab closes and cannot be reopened.
Topology
Tasks
Configure OSPF on all three routers according to the topology diagram to achieve these goals:
1. Enable OSPF on all interfaces using the network statement and match the network mask of each interface.
2. Ensure that all networks are advertised between the routers.
3. Ensure that all routers use OSPF process ID 1 and that the Lo0 interface is used for the router ID.
4. Configure OSPF MD5 authentication on every physical interface running OSPF using key 1 and the password ccnp321.