Default int range et0/0-1
Int range e0/0 - 1
Sw trunk encap dot1
Switch mode trunk
Channel-group 2 mode passive
No shut
Spanning-tree vlan 10 priority 0
Spanning-tree vlan 30 priority 0

3 dB of gain = +3 dB = doubles signal strength (Let's say, the base is P. So 10*log10(P/P)= 0 dB and 10*log10(2P/P) = 10*log10(2) = 3dB -> double signal)

The IP protocol was designed for use on a wide variety of transmission links. Although the maximum length of an IP datagram is 65535, most transmission links enforce a smaller maximum packet length limit, called an MTU. The value of the MTU depends on the type of the transmission link. The design of IP accommodates MTU differences since it allows routers to fragment IP datagrams as necessary. The receiving station is responsible for the reassembly of the fragments back into the original full size IP datagram.
Fragmentation and Path Maximum Transmission Unit Discovery (PMTUD) is a standardized technique to determine the maximum transmission unit (MTU) size on the network path between two hosts, usually with the goal of avoiding IP fragmentation. PMTUD was originally intended for routers in IPv4. However, all modern operating systems use it on endpoints.
The TCP Maximum Segment Size (TCP MSS) defines the maximum amount of data that a host is willing to accept in a single TCP/IP datagram. This TCP/IP datagram might be fragmented at the IP layer. The MSS value is sent as a TCP header option only in TCP SYN segments. Each side of a TCP connection reports its MSS value to the other side. Contrary to popular belief, the MSS value is not negotiated between hosts. The sending host is required to limit the size of data in a single TCP segment to a value less than or equal to the MSS reported by the receiving host.
TCP MSS takes care of fragmentation at the two endpoints of a TCP connection, but it does not handle the case where there is a smaller MTU link in the middle between these two endpoints.
PMTUD was developed in order to avoid fragmentation in the path between the endpoints. It is used to dynamically determine the lowest MTU along the path from a packet's source to its destination.
Reference: http://www.cisco.com/c/en/us/support/docs/ip/generic-routing-encapsulation- gre/25885-pmtud-ipfrag.html (there is some examples of how TCP MSS avoids IP Fragmentation in this link but it is too long so if you want to read please visit this link) Note: IP fragmentation involves breaking a datagram into a number of pieces that can be reassembled later.
If the DF bit is set to clear, routers can fragment packets regardless of the original DF bit setting
-> Answer D is not correct.

https://en.wikipedia.org/wiki/Routing_table
In computer networking a routing table, or routing information base (RIB), is a data table stored in a router or a network host that "lists the routes to particular network destinations".

https://www.cisco.com/c/en/us/td/docs/routers/asr9000/software/asr9k-r7-
5/mpls/configuration/guide/b-mpls-cg-asr9000-75x/implementing-mpls-oam-74x.html