Lab Simulation 36
Guidelines
This is a lab item in which tasks will be performed on virtual devices.
- Refer to the Tasks tab to view the tasks for this lab item.
- Refer to the Topology tab to access the device console(s) and perform the tasks.
- Console access is available for all required devices by clicking the device icon or using the tab(s) above the console window.
- All necessary preconfigurations have been applied.
- Do not change the enable password or hostname for any device.
- Save your configurations to NVRAM before moving to the next item.
- Click Next at the bottom of the screen to submit this lab and move to the next question.
- When Next is clicked, the lab closes and cannot be reopened.
Topology

Tasks
EIGRP is preconfigured on all routers. Configure R10 and R20 to complete these tasks.
Task 1:
Modify the existing ACL on R10 so that EIGRP routes are received from R20 and R30.
- The modification should only allow EIGRP routes to pass.
- Do not remove any configuration from R10 to achieve this task.
Task 2:
Configure CoPP on R20 to achieve these results:
- Permit ICMP traffic from 192.168.24.0/24.
- Limit traffic to 8,000 bps.
- Discard additional packets.

Refer to the exhibit. An engineer configures EIGRP but the routers fail to form a neighborship.
What is the reason for the failure?

Refer to the exhibit. An engineer is troubleshooting an issue with non-Wi-Fi interference on the 5- GHz band. The engineer has enabled Cisco CleanAir and set the appropriate traps, but the AP does not change the channel when it detects significant interference. Which action will resolve the issue?

Select the benefits of implementing Cisco DNA Center. (Choose all that apply.)

Which TLV value must be added to Option 43 when DHCP is used to ensure that APs join the WLC?