Online Access Free Cisco.350-501.v2022-10-19.q228 Practice Test (Page 26)

350-501 Exam Question 121

Refer to the exhibit.

Which configuration must be implemented on router R8 so that it will establish OSPF adjacency with R5?
A)

A.Option D

B.Option A

C.Option C

D.Option B

350-501 Exam Question 122

An engineer must implement QoS to prioritize traffic that requires better service throughout the network. The engineer started by configuring a class map to identify the high-priority traffic. Which additional tasks must the engineer perform to implement the new QoS policy?

A.Create a route map to manipulate the routes that are entered into the routing table and then attach the route map to an interface using a service policy.

B.Attach the class map to a policy map within a VRF to segregate the high-priority traffic and then attach the policy map to an interface in another VRF.

C.Attach the class map to a policy map that sets the minimum bandwidth allocated to the classified traffic and designates the action to be taken on the traffic.

D.Attach the class map to a policy map that designates the action to be taken on the classified traffic and then attach the policy map to an interface using a service policy.

350-501 Exam Question 123

Refer to the exhibit. A network operator is attempting to configure an IS-IS adjacency between two routers, but the adjacency cannot be established. To troubleshoot the problem, the operator collects this debugging output. Which interface are misconfigured on these routers?

A.Option C

B.Option A

C.Option D

D.Option B

350-501 Exam Question 124

Refer to the exhibit. An engineer must configure router R2 as the new P router in the network.
Which configuration must be applied to R2 to enable LDP-IGP Sync on its L2 IS-IS adjacencies?