Online Access Free Cisco.350-501.v2023-04-05.q150 Practice Test (Page 29)

350-501 Exam Question 136

Refer to the exhibit.

A network administrator implemented MPLS LDP changes on PE-A LSR device. The engineer must ensure there are no LDP peer are fully operational. Which LDP feature must the engineer apply to the existing configuration to eliminate the problem?

A.Configure MPLS LDP IGP synchronization on the network.

B.Configure MPLS LDP NSR for all LDP sessions.

C.Enable LDP session protection under the routing protocol.

D.Disable IP CEF on routers running LDP and enable LDP.

350-501 Exam Question 137

Refer to the exhibit:

A network engineer is implementing a BGP protocol. Which effect of the local-as keyword in this configuration is true?

A.It enables peer 192.168.1.2 to establish a BGP relationship with R1 using AS 65012 and the VPNv4 address family

B.It enables peer 192.168.1.2 to establish a BGP relationship with R1 using AS 65012 without additional configuration

C.It enables peer 192.168.1.2 to establish a BGP relationship with R1 using AS 65112 and the VPNv4 address family

D.It enables peer 192.168.1.2 to establish a BGP relationship with R1 using AS 65112 without additional configuration.

350-501 Exam Question 138

Refer to the exhibit:

Which statement about the neighbor statements for 192.168.1.1 is true?

A.The router must have TDP configured for the send-label command to operate

B.The router sends BGP labels for its prefixes to this peer

C.The router sends only a label for the prefix for LoopbackO.

D.The neighbor router receives at least four labels from this router

350-501 Exam Question 139

Refer to the exhibit.

Refer to the exhibit. Tier 2 ISP A on AS 653 is connected to two Tier 1 ISPs on AS 321 and AS 51 respectively. The network architect at ISP A is planning traffic flow inside the network to provide predictable network services. Cisco Express Forwarding is disabled on the edge router. How should the architect implement BGP to direct all traffic via the Tier 1 ISP with next-hop 7.4.5.2?

A.Implement the BGP routing protocol and run the bgp deterministic-med command.

B.Implement the BGP routing protocol and the maximum-paths 2 configuration.

C.Implement MP-BGP with a 4-byte AS number with the bgp best path compare-routerid command.

D.Implement BGP route-reflector functionality with the bgp always-compare-med configuration.

350-501 Exam Question 140

Refer to the exhibit.

A network operator must configure CSR1 interlaces GigabitEihernet2 and GigabitEthemet to rewrite VLAN tags 12 and 21 for traffic between R1 and R2 respectively. Which configurator accomplishes this task?
A)