Online Access Free Cisco.350-501.v2024-06-28.q419 Practice Test (Page 8)

350-501 Exam Question 31

Which two tasks must an engineer perform when implementing LDP NSF on the network? (Choose two.)

A.Disable Cisco Express Forwarding.

B.Enable NSF for EIGRP.

C.Enable NSF for the link-state routing protocol that is in use on the network.

D.Implement direct connections for LDP peers.

E.Enable NSF for BGP.

350-501 Exam Question 32

Refer to the exhibit.

An engineer is configuring path selection on router R1 for two ASNs as shown. Which additional task must the engineer perform on Router 1 so that all outbound traffic utilizes the link between R1 and R3 to reach ASN 4567?

A.Configure a high med on the peer to ASN 4567.

B.Configure a high weight on the peer to ASN 4567.

C.Configure a low weigh! on the peer to ASN 4567.

D.Configure an AS path prepend on the peer to ASN 4567.

350-501 Exam Question 33

Refer to the exhibit:

An engineer is preparing to implement link aggregation configuration.
Which statement al about this configuration is true?

A.The switch port negotiates an EtherChannel if it receives LACP packets from a connected peer

B.The switch port passively negotiates an EtherChannel if it receives PAgP packets from a connected peer

C.The switch port actively sends packets to negotiate an EtherChannel using PAgP

D.The switch port accepts LACP and PAgP packets from a connected peer and negotiate an EtherChannel using the common EtherChannel mode.

350-501 Exam Question 34

Refer to the exhibit an engineer working for a private telecommunication company with an employee Id: 4065:96:080 upgrades the WAN link between routers ASBR-101 and ASBR-201 to
1Gb by Installing a new physical connection between the Gi3 Interfaces.
Which BGP attribute must the engineer configure on ASBR-201 so that the existing WAN link on Gi2 Is maintained as a backup?