Online Access Free Cisco.350-601.v2025-10-09.q638 Practice Test (Page 46)

350-601 Exam Question 221

An engineer must generate a checkpoint of the running configuration on a Cisco Nexus Switch. The checkpoint file name must be called "before_maintenance' and should be used for recovering the switch to its pre- maintenance state. The rollback of the checkpoint to running configuration should only occur if no errors occur. Which two configuration commands must be used to meet these requirements? (Choose two.)

A.rollback running-conflg checkpoint before.maintenance

B.checkpoint file before_maintenance

C.rollback running-conflg file before_maintenance atomic

D.checkpoint before.maintenance

E.rollback checkpoint rile before_maintenance stop-at-first-failure

350-601 Exam Question 222

Refer to the exhibit.

In a bidirectional PIM network using Phantom RP as an RP redundancy mechanism, two Cisco NX-OS routers have these requirements:
* R1 must be the active RP.
* R2 must be the backup RP that is used only if R1 is not reachable
Drag and drop the configuration steps to complete the configuration for Router 2. Not all configuration steps are used.

350-601 Exam Question 223

Which configuration statically assigns VSAN membership to a virtual Fibre Channel interface?

A.switch(config-vsan-cb># vsan 100 bind interface fc 3/1

B.switch<config-vsan-db)# vsan 100 bind interface vfc 31

C.switch(config-vsan-db># vsan 100 fc 3/1

D.switch(config-vsan-db)# vsan 100 interface vfc 31

350-601 Exam Question 224

Drag and Drop Question
A Cisco Nexus Embedded Event Manager (EEM) must be configured to monitor when zone set commands are issued on the Cisco MDS 9000 Series Switch. The EEM applet must permit the command to execute and print a message to the terminal only. Drag and drop the code snippets from the bottom onto the blanks in the code to complete the EEM configuration. Not all code snippets are used.