https://www.cisco.com/c/en/us/td/docs/security/ise/2-4/admin_guide/b_ISE_admin_guide_24/ m_ise_interoperability_mdm.html
https://www.cisco.com/c/en/us/td/docs/security/ise/2-4/admin_guide/b_ISE_admin_guide_24/
https://www.cisco.com/c/en/us/td/docs/security/ise/2-4/admin_guide/b_ISE_admin_guide_24/ m_ise_interoperability_mdm.html

To understand DHCP snooping we need to learn about DHCP spoofing attack first.
DHCP spoofing is a type of attack in that the attacker listens for DHCP Requests from clients and answers them with fake DHCP Response before the authorized DHCP Response comes to the clients. The fake DHCP Response often gives its IP address as the client default gateway -> all the traffic sent from the client will go through the attacker computer, the attacker becomes a "man-in-the-middle".
The attacker can have some ways to make sure its fake DHCP Response arrives first. In fact, if the attacker is "closer" than the DHCP Server then he doesn't need to do anything. Or he can DoS the DHCP Server so that it can't send the DHCP Response.
DHCP snooping can prevent DHCP spoofing attacks. DHCP snooping is a Cisco Catalyst feature that determines which switch ports can respond to DHCP requests. Ports are identified as trusted and untrusted.
Only ports that connect to an authorized DHCP server are trusted, and allowed to send all types of DHCP messages. All other ports on the switch are untrusted and can send only DHCP requests. If a DHCP response is seen on an untrusted port, the port is shut down.
The port connected to a DHCP server should be configured as trusted port with the "ip dhcp snooping trust" command. Other ports connecting to hosts are untrusted ports by default.
In this question, we need to configure the uplink to "trust" (under interface Gi1/0/1) as shown below.

Explanation The user "admin5" was configured with privilege level 5. In order to allow configuration (enter global configuration mode), we must type this command: (config)#privilege exec level 5 configure terminal Without this command, this user cannot do any configuration. Note: Cisco IOS supports privilege levels from 0 to 15, but the privilege levels which are used by default are privilege level 1 (user EXEC) and level privilege 15 (privilege EXEC)