350-801 Exam Question 86
Refer to the exhibit. An engineer is troubleshooting an E1 interface module that fails to come up.
The E1 module must have these configurations:
- The linecode type must be Alternate Mark Inversion.
- The frame type must be Extended Super Frame.
- All available channels must be used.
An engineer already deployed the configurations shown in the exhibit to the Cisco voice gateway.
Which additional configurations must be performed to resolve the issue?
The E1 module must have these configurations:
- The linecode type must be Alternate Mark Inversion.
- The frame type must be Extended Super Frame.
- All available channels must be used.
An engineer already deployed the configurations shown in the exhibit to the Cisco voice gateway.
Which additional configurations must be performed to resolve the issue?
350-801 Exam Question 87
Which type of input is required when configuring a third-party SIP phone?
350-801 Exam Question 88
Which device is a Cisco IP Phone 8800 series phone registered in, if it was registered using Mobile and Remote Access?
350-801 Exam Question 89
An engineer builds this configuration on a Cisco IOS gateway for fax dial-peers:
Which command is required to complete the configuration?
Which command is required to complete the configuration?
350-801 Exam Question 90
Which field of a Real-Time Transport Protocol packet allows receiving devices to detect lost packets?