The issue is caused by the lack of a default route defined in the /etc/sysconfig/network-scripts/ifcfg-enp0s3 file. A default route is a special route that specifies where to send packets that do not match any other routes in the routing table. Without a default route, the server will not be able to communicate with hosts outside its local network. The default route is usually configured with the GATEWAY option in the network interface configuration file. For example, to set the default gateway to 192.168.1.1, the file should contain:
GATEWAY=192.168.1.1
The other options are not causing the issue. The DNS address is not commented out in the configuration file, it is specified with the DNS1 option. The search entry in the /etc/resolv.conf file is correct, it specifies the domain name to append to unqualified hostnames. Wired connection 1 is online, as indicated by the ONBOOT=yes option and the output of ip link show enp0s3 command. References: Configuring IP Networking with nmcli; Configuring IP Networking with ifcfg Files

To delete a file from a Git repository, the administrator can use the command git rm app.conf (D). This will remove the file "app.conf" from the working directory and stage it for deletion from the repository. The administrator can then commit the change with git commit -m "Delete app.conf" to finalize the deletion. The other commands will not delete the file, but either tag, commit, or checkout the file. References:
* [CompTIA Linux+ Study Guide], Chapter 10: Working with Git, Section: Deleting Files with Git
* [How to Delete Files from Git]

The most likely reason the timer will not start is that the checkdiskspace.timer should be configured to allow manual starts. By default, systemd timers do not allow manual activation via systemct1 start, unless they have RefuseManualStart=no in their [Unit] section. This option prevents users from accidentally starting timers that are meant to be controlled by other mechanisms, such as calendar events or dependencies. To enable manual starts for checkdiskspace.timer, the administrator should add RefuseManualStart=no to its [Unit] section and reload systemd.
The other options are not correct reasons for the timer not starting. The checkdiskspace.timer unit does not need to be enabled via systemct1 enable, because enabling a timer only makes it start automatically at boot time or after a system reload, but does not affect manual activation. The timers.target does not need to be reloaded to get the new configuration, because reloading a target only affects units that have a dependency on it, but does not affect manual activation. The checkdiskspace.timer does not need to be started using the sudo command, because the administrator is already running systemct1 as root, as indicated by the # prompt. References: systemd.timer(5) - Linux manual page; systemct1(1) - Linux manual page

The correct command to block the IP address 192.168.10.50 from accessing a Linux server is iptables -A INPUT -s 192.168.10.50 -j DROP. This command appends a rule to the INPUT chain that matches the source address 192.168.10.50 and jumps to the DROP target, which discards the packet. The other commands are incorrect because they either have invalid syntax, wrong parameters, or wrong order of arguments.
References: CompTIA Linux+ Study Guide, Fourth Edition, page 457-458.

See the explanation below.
Explanation:
yum install httpd
systemct1 --now enable httpd
systemct1 status httpd
netstat -tunlp | grep 80
pkill <processname>
systemct1 restart httpd
systemct1 status httpd