An LTM Administrator receives an email from the NOC stating that the switch connected to the backend server was shut down for maintenance. The BIG-IP device handles only UDP traffic. The BIG IP device did not fail over to a DR location when no pool members were available.
When the LTM Administrator checks the pool, it confirms that the monitor is still marking UP the pool member.
A tcpdump of the traffic shows the following output:

A list of the monitor configuration shows the following:

Which two modifications to the LTM configuration will mark this pool member down, when the switch is down? (Choose two.)

An organization's development team creates an application to put behind the F5 LTM device. The application can be quite load intensive at first, and then evens out over time. The team's load balancing method needs to select a pool after taking into account the pool member's response over the time to avoid landing on a busy pool member.
Which of the following load balancing methods meets this requirement?

Refer to the exhibit.

A pool is contoured with four members. A user has a current connection established with 10.18.1.40. The virtual server has a persistence Profile configured.

Refer to the exhibit

Given the bigip conf extract shown where the servers only talk http on port 80, which node will receive the next user request?

An LTM Specialist needs to create a pool with a set of monitor that checks both the pool members and corresponding application service ports. The pool members have services on port 80. The application service is on port 8009.
The LTM device should load balance traffic to the pool member when the pool member and corresponding application service pass monitor.
Which monitor and parameter set meets this requirement?