Online Access Free Fortinet.NSE5_FAZ-6.4.v2022-02-02.q31 Practice Test (Page 7)

NSE5_FAZ-6.4 Exam Question 26

In the FortiAnalyzer FortiView, source and destination IP addresses from FortiGate devices are not resolving to a hostname.
How can you resolve the source and destination IP addresses, without introducing any additional performance impact to FortiAnalyzer?

A.Resolve IP addresses on a per-ADOM basis to reduce delay on FortiView while IPs resolve

B.Configure # set resolve-ip enable in the system FortiView settings

C.Configure local DNS servers on FortiAnalyzer

D.Resolve IP addresses on FortiGate

NSE5_FAZ-6.4 Exam Question 27

Which two statements are true regarding log fetching on FortiAnalyzer? (Choose two.)

A.Log fetching allows the administrator to fetch analytics logs from another FortiAnalyzer for redundancy.

B.Log fetching can be done only on two FortiAnalyzer devices that are running the same firmware version.

C.Log fetching allows the administrator to run queries and reports against historical data by retrieving archived logs from one FortiAnalyzer device and sending them to another FortiAnalyzer device.

D.A FortiAnalyzer device can perform either the fetch server or client role, and it can perform two roles at the same time with the same FortiAnalyzer devices at the other end.

NSE5_FAZ-6.4 Exam Question 28

What remote authentication servers can you configure to validate your FortiAnalyzer administrator logons? (Choose three)

A.Local

B.TACACS+

C.PKI

D.RADIUS

E.LDAP

NSE5_FAZ-6.4 Exam Question 29

On the RAID management page, the disk status is listed as Initializing.
What does the status Initializing indicate about what the FortiAnalyzer is currently doing?

A.FortiAnalyzer is ensuring that the parity data of a redundant drive is valid

B.FortiAnalyzer is writing data to a newly added hard drive to restore it to an optimal state

C.FortiAnalyzer is writing to all of its hard drives to make the array fault tolerant

D.FortiAnalyzer is functioning normally

NSE5_FAZ-6.4 Exam Question 30

In FortiAnalyzer's FormView, source and destination IP addresses from FortiGate devices are not resolving to a hostname. How can you resolve the source and destination IPs, without introducing any additional performance impact to FortiAnalyzer?

A.Resolve IPs on FortiGate