GB0-191-ENU Exam Question 96
In the switching network shown in the figure, all switches have enabled the STP protocol.

SWA was selected as the root bridge. According to the information in the figure, the _______ port should be set to the Blocking state. (Multiple choice)

SWA was selected as the root bridge. According to the information in the figure, the _______ port should be set to the Blocking state. (Multiple choice)
GB0-191-ENU Exam Question 97
The two routers MSR-1 and MSR-2 complete dynamic routing learning through RIP, and you can see the following debug information on MSR-1:
*Nov 26 02:20:25:353 2008 H3C RM/6/RMDEBUG: RIP 1: Sending v2 request on Serial 0/0 from 3.3.3.3
*Nov 26 02:20:25:353 2008 H3C RM/6/RMDEBUG: RIP 1: Sending request on interface Serial0/0 from 3.3.3.3 to 224.0.0.9
*Nov 26 02:20:25:400 2008 H3C RM/6/RMDEBUG: RIP 1: Receiving v2 request on Serial0/0 from 3.3.3.1
According to the debug information, ______ can be inferred. (Multiple choice)
*Nov 26 02:20:25:353 2008 H3C RM/6/RMDEBUG: RIP 1: Sending v2 request on Serial 0/0 from 3.3.3.3
*Nov 26 02:20:25:353 2008 H3C RM/6/RMDEBUG: RIP 1: Sending request on interface Serial0/0 from 3.3.3.3 to 224.0.0.9
*Nov 26 02:20:25:400 2008 H3C RM/6/RMDEBUG: RIP 1: Receiving v2 request on Serial0/0 from 3.3.3.1
According to the debug information, ______ can be inferred. (Multiple choice)
GB0-191-ENU Exam Question 98
The two empty-configured routers MSR-1 and MSR-2 are connected as follows: HostA----GE0/0--MSR-1--S1/0---------S1/0-- MSR-2--GE0/0----HostB
The WAN interconnection network segment of the two routers is 192.168.10.0/30, and the GE0/0 address of MSR-1 is 172.16.1.1/24.
After configuration, HostA can ping through 172.16.1.1, and the WAN between the two routers is also interoperable.
Now the following configuration is added to MSR-1:
[MSR-1]rip
[MSR-1-rip-1]network 192.168.10.1
[MSR-1-rip-1]network 172.16.1.1
And started the RIP process on MSR-2.
Which of the following configurations must be done on the MSR-2 to ensure that the MSR-2 learns the RIP route? (multiple choice)
The WAN interconnection network segment of the two routers is 192.168.10.0/30, and the GE0/0 address of MSR-1 is 172.16.1.1/24.
After configuration, HostA can ping through 172.16.1.1, and the WAN between the two routers is also interoperable.
Now the following configuration is added to MSR-1:
[MSR-1]rip
[MSR-1-rip-1]network 192.168.10.1
[MSR-1-rip-1]network 172.16.1.1
And started the RIP process on MSR-2.
Which of the following configurations must be done on the MSR-2 to ensure that the MSR-2 learns the RIP route? (multiple choice)
GB0-191-ENU Exam Question 99
The number of available host addresses contained in the natural classification network segment corresponding to IP address 172.15.1.1 is ___________. (Please fill in Arabic numerals)
GB0-191-ENU Exam Question 100
The MAC address table on a layer 2 switch is shown in the figure.

When the switch receives a frame with a destination MAC address of 00-13-72-8E-4B-C1 from the E1/0/2 interface, the switch will ______ the frame.

When the switch receives a frame with a destination MAC address of 00-13-72-8E-4B-C1 from the E1/0/2 interface, the switch will ______ the frame.
