An MSR router has three interfaces whose IP addresses are Loopback0:192.168.1.1/32, Loopback1:192.168.2.1/32, and GE0/0:192.168.3.1/30.
Run OSPF protocol and enable OSPF on three interfaces at the same time, then the Router ID selected by this router is _______.

In IS-IS, _______ has both Level-1 and Level-2 link state information.

e As shown, RTA, RTB are located in AS 100. The two establish IBGP neighbors, and there are no routes for RTA and RTC Internet segments on RTB: RTC is located in AS 200 and establishes EBGP neighbors with RTA.
Its main configuration is as follows:
RTA]
bgp 100
peerRTC as-number 200
peerRTB as-number 100
RTB]
bgp 100
peerRTA as-number 100
RTC]
bgp 200
peerRTA as-number 100
RTC cannot send 192.168.1.0/24 route to RTA, but 92.168.1.0/24 route does not appear in RTB's IP 1 routing table.
To solve the above problems, what adjustments should be made in the configuration?

How to configure route-polic to import BGP route with MED value of 1000 in OSPF 100 process?

The administrator wants to configure the RIP routing priority value to be 60 on the MSR router. Which of the following commands is correct?