Refer to the exhibit.

A user uses Microsoft Windows for a wireless session. Based on the output shown in the exhibit for the selected Aruba AP, what is the possible problem with this user's wireless session?

Which ArubaOS CLI command can an administrator execute to determine if AP load balancing is enabled in a cluster?

An administrator stages an AP and re-provisions it as a RAP from the Mobility Master (MM). When re-provisioning the RAP, the administrator must enter a user's credentials. What is the purpose of these credentials?

Refer to the exhibit.

An administrator implements the MultiZone feature. The administrator sets up five zones as shown in the exhibit in this configuration:
-Zone A has six controllers that form a cluster.
-Zone B has three controllers that from a cluster.
-Zones C, D, and E have a single standalone controller each.
A total of 13 VAPs are created across the five zones. Aruba Mobility Controllers (MCs) in Zones A, B and C run ArubaOS 8.1.0.1 MCs in zones D and E run ArubaOS 8.1.0.2. Some APs do not join their respective data zones.
What could cause this problem?

An administrator purchases a RAP and has it shipped directly to a branch office. The branch office plugs in the RAP and the RAP contacts Aruba Activate. The RAP learns the Mobility Controller (MC) IP address andconnects to it. However, the connection fails.
Upon verifying the MC IP address in Aruba Activate, what should the administrator do to allow the RAP connection to succeed?