A Network Technician has been given a list of `show` commands to validate the configuration of a newly installed HPE Aruba Networking CX switch. The technician needs to verify the status of all IP- configured interfaces on the switch, including VLAN interfaces (SVIs) and the out-of-band management port.
The technician wants a single command that produces a table-like output, with one line per interface, showing the interface name, its IP address, and its status. Which of the following validation commands is the best tool for this specific purpose?

What are the default AOS-CX user groups? (Select three)

A Network Operator is configuring a port on an HPE Aruba Networking CX switch that will connect to a VoIP phone. The phone needs to have its own traffic on the voice VLAN (VLAN 20), while a user's computer connected to the phone's built-in switch needs to be on the data VLAN (VLAN 10). Which VLAN configuration concept is required on the switch port to support this setup?

A Solutions Architect is deploying a new two-tier campus network. The core switch is an HPE Aruba Networking CX 8325, and it must be configured to route traffic between three user VLANs (VLAN 10, VLAN 20, VLAN 30) and provide a default route to the internet via a firewall at
172.16.1.1. The architect has documented the required SVI configurations and the static default route.
Initial State:
* VLANs 10, 20, and 30 are already created on the switch.
* The connection to the firewall is on port 1/1/48, which is in VLAN 1.
Required Configuration:
* VLAN 10 SVI: IP Address 10.10.10.1/24
* VLAN 20 SVI: IP Address 10.10.20.1/24
* VLAN 30 SVI: IP Address 10.10.30.1/24
* Firewall Uplink SVI (VLAN 1): IP Address 172.16.1.2/30
* Default Route: Pointing to the firewall at 172.16.1.1 Which of the following configuration sets correctly implements the specified Layer 3 routing requirements?

When might a switch add a VLAN tag to a frame?